Description

A high-gloss, high-build, coating formulated to provide a tough, protective finish for interior concrete floors. This two-component product is very low in VOC and odor, non-flammable, and minimal shrinking upon curing. It provides excellent resistance to abrasion, marring, scuffing, foot and vehicular traffic as well as chemicals including oil, grease, hydraulic fluid, gasoline, many solvents and moderate acids and alkalis. It is ideal for use in factories, warehouses, garage floors, covered parking decks, aircraft hangars, service stations, and other applications where a heavy-duty coating is required. PRODUCT CHARACTERISTICS: ♦ Chemical resistant ♦ Abrasion & wear resistant ♦ High film building ♦ Easy mixing & spreading ♦ Self-leveling ♦ Very Low Odor and VOC ♦ Non-flammable ♦ High gloss.

MIXING & APPLICATION 1. Contents are pre-weighed. Do not mix less than full amount. 2. On porous, bare concrete, first apply a coat of 2K Waterborne Epoxy Clear Sealer (197-8001) following label directions in order to increase the adhesion of this coating and reduce outgassing imperfections. 3. Apply when air and surface temperature is 60-90oF and relative humidity is less than 85%. 4. Wear impervious gloves and long sleeves while working with this material. Discard gloves when finished. 5. Pour entire contents of kit (one container of Part A – Curing Agent and two containers of Part B – Epoxy) into a five gallon metal pail. Scrape container sides to make sure that all material is removed. 6. Blend thoroughly with a mixer mounted on an electric drill for 2-3 minutes at medium speed. Do not “whip” air into the mixture. Scrape sides to make sure that all material is completely blended. 7. Pot life while in the container is 30-45 minutes at 77oF. Warmer temperatures will shorten the pot life while cooler temperatures will extend pot life. WARNING! MIXTURE WILL GET WARM AFTER BLENDING AND VERY HOT TOWARD THE END OF THE POT LIFE. USE CAUTION! 8. No induction time is needed; use immediately. 9. Do not thin. Pour blended contents onto the surface and spread with a notched squeegee or roller. A brush may be used for small areas and trim. Spreading rate is 100-125 sq. ft. per gallon (280-350 sq. ft. per kit) for a dry film thickness of 12-16 mils. 10. Do not overwork the coating. This product is self-leveling. 11. Coating may be walked on or recoated after 18-24 hours at 77oF. Allow 3-5 days of curing before subjecting to heavy-duty use. Cooler temperatures will extend cure time while warmer temperatures will accelerate cure time. 12. Clean up equipment immediately after use with xylene following label directions for use and proper protective equipment. VISCOSITY (mix): 94-102 KU. GLOSS (mix): 90%+. POT LIFE: 30-45 min. @ 77oF. COVERAGE: 100-125 sq.ft. per gallon, 280-350 sq.ft. per kit. DRY TIME: Light Traffic 18-24 hours @ 77oF. HEAVY DUTY USE: 3-5 days @ 77oF.                                                          Packaged in a 3 gallon kit. Available in Clear, Gray or Beige.