Sale!

DiamaBrush Hardwood Prep & Mastic Removal Tools

$307.35$337.00

Original price was: $421.20.Current price is: $337.00.
Original price was: $414.26.Current price is: $331.45.
Original price was: $405.60.Current price is: $324.50.
Original price was: $396.22.Current price is: $317.00.
Original price was: $384.16.Current price is: $307.35.

Description

The Diamabrush™ Hardwood Prep Tool is the first step to rejuvenated hardwood floors!  Designed to remove polyurethane and carpet adhesives from hardwood floors, effectively preparing the floor for re-finishing. The Hardwood tool will effectively remove these coatings getting back to the bare wood, saving end-users time and money. This tool is designed for dry use only and fits your existing standard rotary floor machines. NOTE: For Single Disc Counter Clock Wise (CCW) Rotation Only.

The diamond cutting surface remains free of melted or gummed up coatings and retains its sharp cutting points throughout the life of the tool. Replace your conventional sandpaper methods which means no more wasted time or money changing caramelized sandpaper. Blades feature 2 cutting edges. When diamonds wear on one side, simply turn the blades over and use cutting edge on other side.

The Hardwood Prep Tool is designed with replaceable blades which enable users to order a replacement kit and easily change used or worn blades, thus minimizing downtime. Simply loosen two screws and replace.  DiamaBrush Hardwood Prep and Mastic Tool is a Non-returnable item.

Does not include clutch plate or riser block. Must be ordered separately. 

Available sizes: 12″, 13″, 14″, 15″ and 16″.

Determining Diameters

Block Diameter: Lay the brush on the bristles, block side up. Measure the actual outside diameter of the block (not the bristle flare). See photo below for reference (measurement B).

Center Hole Diameter: Lay the brush on the bristles block side up. Remove mounting hardware, if any. Measure actual inside diameter of the center hole. See photo below for reference (measurement D).

Floor Machine Brushes, Pads, Drivers & Clutch Plates - Determining Diameters

Once the correct size of brush and the proper clutch plate is determined, a few questions will enable you to select the correct type of brush or pad driver that is needed to fill your needs.

NOTE: Malish brushes are designed to fit each machine as shown, even though the block diameter listed on the charts may vary slightly from the diameter of the block originally supplied with the machine. 

What is the make and model number of the machine?

When calling customer service toll FREE at 1-888-614-6584, please have the machine manufacturer and model number to help determine the block size, center hole diameter and clutch plate necessary to attach the block to the machine. If the machine size is not apparent from the model number, please provide this specification.