Sale!

Step 1 Concrete Prep Plus™ Tools 25 Grit CCW & CW

$548.00$923.00

$923.00
$923.00
$902.00
$902.00
$823.00
$823.00
$747.00
$747.00
$728.00
$728.00
$642.00
$642.00
$633.00
$633.00
$562.00
$562.00
$548.00
$548.00

Description

The first step in the Diamabrush Concrete Polishing System involves abrading the surface to prepare it for polishing. The Diamabrush Concrete Prep Tool Plus™ mechanically etches and prepares bare concrete floors to receive a coating, creating superior coating adhesion.  The Concrete Prep Plus™ will also remove a thin layer of paint or epoxy. This tool consists of a super tough 25 diamond grit that is bonded to a metallic backing and assembled to flexible, steel spring blades. The operator can prepare and profile old, worn, dirty floors using standard cleaning equipment such as automatic scrubbers. The patent pending Concrete Prep Tool can be refurbished by simply replacing the blades.  Concrete Prep Plus™ is specially designed to last up to 3 to 4 times longer (up to 50,000 sq.ft.) than our standard Concrete Prep Tool. The process is easy. Simply order a replacement kit, loosen two screws, replace the blade, and then re-tighten the screws. It’s just that simple.    Available in 12″ thru 20″, Counter Clock Wise (CCW) or Clock Wise (CW).                              Does not include clutch plate or riser block. Must be ordered separately.                               

Determining Diameters

Block Diameter: Lay the brush on the bristles, block side up. Measure the actual outside diameter of the block (not the bristle flare). See photo below for reference (measurement B).

Center Hole Diameter: Lay the brush on the bristles block side up. Remove mounting hardware, if any. Measure actual inside diameter of the center hole. See photo below for reference (measurement D).

Floor Machine Brushes, Pads, Drivers & Clutch Plates - Determining Diameters

Once the correct size of brush and the proper clutch plate is determined, a few questions will enable you to select the correct type of brush or pad driver that is needed to fill your needs.

NOTE: Malish brushes are designed to fit each machine as shown, even though the block diameter listed on the charts may vary slightly from the diameter of the block originally supplied with the machine. 

What is the make and model number of the machine?

When calling customer service toll FREE at 1-888-614-6584, please have the machine manufacturer and model number to help determine the block size, center hole diameter and clutch plate necessary to attach the block to the machine. If the machine size is not apparent from the model number, please provide this specification.